Removal

SUSPENSION: REAR COIL SPRING: REMOVAL

REMOVAL

1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.

3. SEPARATE SKID CONTROL SENSOR WIRE





(a) Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
NOTICE: Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.





(b) Remove the nut and separate the skid control sensor wire.





4. SEPARATE REAR LH FLEXIBLE HOSE
(a) Using a union nut wrench, separate the brake tube from the flexible hose.
(b) Remove the clip and disconnect the flexible hose from the axle beam.
5. SEPARATE REAR RH FLEXIBLE HOSE
HINT: The removal procedure for the RH side is the same as that for the LH side.





6. LOOSEN REAR AXLE BEAM
(a) Loosen the 2 bolts.
NOTICE: Do not remove the bolts.

7. REMOVE REAR ABSORBER CAP
8. REMOVE REAR ABSORBER CAP
9. REMOVE REAR SHOCK ABSORBER CAP LH
10. REMOVE REAR SHOCK ABSORBER CAP RH
11. REMOVE REAR SHOCK ABSORBER LH Removal
12. REMOVE REAR SHOCK ABSORBER RH
HINT: The removal procedure for the RH side is the same as that for the LH side.

13. REMOVE REAR COIL SPRING LH
(a) Lower the jacks slowly.
(b) Remove the coil spring, coil spring insulator upper and coil spring insulator lower.
14. REMOVE REAR COIL SPRING RH
HINT: The removal procedure for the RH side is the same as that for the LH side.