Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION

INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL STEERING ANGLE SENSOR Installation
2. INSTALL SPIRAL CABLE





(a) Check that the ignition switch is turned to OFF.
(b) Confirm that the negative battery terminal is detached.
CAUTION: Do not begin the operation for at least 90 seconds after the negative battery terminal has been detached.

(c) Confirm that the front tires face straight forward.
(d) Confirm that the turn signal switch is in the neutral position.
NOTICE: Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.

(e) Engage the 3 claws and install the spiral cable.
NOTICE: Pull the lock pin out before installing the steering wheel when replacing the spiral cable with a new one.





(f) Connect the airbag connector.
(g) Connect the horn connector.
(h) Connect the steering sensor.
3. INSTALL STEERING COLUMN UPPER COVER Installation
4. INSTALL STEERING COLUMN LOWER COVER Installation
5. ADJUST SPIRAL CABLE
(a) Center the spiral cable.




(1) Turn the spiral cable counterclockwise until it locks.
HINT: The spiral cable turns a maximum of approximately 5 times.




(2) Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.
6. INSTALL STEERING WHEEL ASSEMBLY Installation
7. INSTALL STEERING PAD Installation
8. TURN FRONT WHEELS FACING STRAIGHT AHEAD
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
10. INSPECT SRS WARNING LIGHT
Diagnosis System