Installation

2ZR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: INSTALLATION

INSTALLATION

1. INSTALL THROTTLE BODY ASSEMBLY





(a) Install a new gasket onto the intake manifold.





(b) Install the throttle body assembly with the 2 bolts and 2 nuts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)





(c) Connect the water by-pass hose and the No. 2 water by-pass hose.





(d) Connect the throttle body assembly connector.
2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE
(a) Install air cleaner cap sub-assembly with hose and lock the 2 clamps.





(b) Tighten the hose clamp to the specified torque.
Torque: 3.0 Nm (31 kgf-cm, 27 in-lbf)





(c) Connect the No. 2 ventilation hose.





(d) Connect the wire harness clamp and mass air flow meter connector.
3. ADD ENGINE COOLANT Service and Repair
4. INSPECT FOR COOLANT LEAK Testing and Inspection
5. INSTALL NO. 2 CYLINDER HEAD COVER Installation