ABS (Antilock Brake System)
BRAKE CONTROL: ANTI-LOCK BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART
DIAGNOSTIC TROUBLE CODE CHART
NOTICE: Turn the ignition switch to OFF before removing parts.
HINT:
- If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC.
- When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
- Inspect the fuse and relay before investigating the trouble areas as shown in the table below.
DTC chart of ABS:
C0200 - C0215:
C0226 - C1235:
C1236 - C1243:
C1244 - C1251/U0073:
(*1):
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
- Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
- Clear the DTC.
HINT: In some cases, the Techstream cannot be used when the ABS warning light remains on.
Test Mode DTC of ABS:
