FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2009 >> xB L4-2.4L (2AZ-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Seat Belt Systems >> Seat Belt >> Service and Repair >> Front Seat Inner Belt Assembly >> Installation

Installation








SEAT BELT: FRONT SEAT INNER BELT ASSEMBLY: INSTALLATION

INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.
HINT: The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

1. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)





(a) Install the front seat inner belt with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
NOTICE: Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

(b) Install the wiring harness onto the claw of the front seat cushion shield.





(c) Engage the wiring harness clamp.
(d) Connect the buckle switch connector.
2. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)





(a) Connect the connector to the seat position airbag sensor.





(b) Install the front seat inner belt with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
NOTICE: Do not place the front seat inner belt over the convex areas of the front seat frame adjuster.

(c) Install the wiring harness onto the claw of the front seat cushion shield.
(d) Engage the wiring harness clamp.





(e) Engage the 2 wiring harness clamps.
(f) Connect the buckle switch connector.
(g) Engage the 2 claws and install the front seat cushion cover pad.
(h) Install the front seatback cover band.
3. INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side) Reassembly
4. INSTALL RECLINING ADJUSTER KNOB (for Driver Side) Reassembly
5. INSTALL VERTICAL ADJUSTER COVER (for Driver Side) Reassembly
6. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Driver Side) Reassembly
7. INSTALL FRONT SEAT ASSEMBLY LH (for Driver Side) Installation
8. INSTALL FRONT SEAT ASSEMBLY RH (for Front Passenger Side) Installation
9. INSTALL SEAT TRACK INNER BRACKET COVER Installation
10. INSTALL SEAT TRACK COVER Installation
11. INSTALL FRONT SEAT HEADREST ASSEMBLY





(a) Push in the lock button of the front seat headrest support and install the front seat headrest.
12. INSTALL SEAT TRACK COVER Installation
13. INSTALL SEAT TRACK INNER BRACKET COVER Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
15. INSPECT SRS WARNING LIGHT
Diagnosis System
pro multis Credits:Operation CHARM About Operation CHARM