Bus Buffer ECU Communication Stop Mode

CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Bus Buffer ECU Communication Stop Mode

Bus Buffer ECU Communication Stop Mode

DESCRIPTION





HINT: For vehicle with accessory.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTICE:
- Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT: Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

PROCEDURE

1. CHECK CAN BUS LINE FOR DISCONNECTION (ACCESSORY BUS BUFFER BRANCH WIRE)




(a) Turn the ignition switch off.
(b) Disconnect the C26 accessory bus buffer connector.
(c) Measure the resistance according to the value in the table below.
Standard Resistance:






NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO ACCESSORY BUS BUFFER ((CAN-H, CAN-L))
OK -- CHECK ACCESSORY CIRCUIT