Removal

2AZ-FE COOLING: WATER PUMP: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE UNDER COVER
3. REMOVE REAR ENGINE UNDER COVER RH
4. DRAIN ENGINE COOLANT Service and Repair
5. REMOVE FAN & GENERATOR V BELT Removal
6. REMOVE GENERATOR ASSEMBLY Removal





7. REMOVE WATER PUMP PULLEY
(a) Using SST, remove the 4 bolts and water pump pulley.
SST: 09960-10010
09962-01000
09963-00700
8. REMOVE WATER PUMP ASSEMBLY





(a) Remove the crankshaft position sensor clamp from the water pump.
(b) Disconnect the crankshaft position sensor wire from the clamp bracket.





(c) Remove the 4 bolts, 2 nuts and clamp bracket.





(d) Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
NOTICE: Be careful not to damage the contact surfaces of the water pump and cylinder block.