Installation

2AZ-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL REAR CRANKSHAFT OIL SEAL
(a) Apply MP grease to the lip of a new oil seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST: 09223-15030
SST: 09950-70010
09951-07100

NOTICE:
- Keep the lip free from foreign matter.
- Do not tap on the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)
(a) Clean the 8 bolts and 8 bolt holes.
(b) Apply adhesive to 2 or 3 threads of the 8 bolts.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(d) Install the front drive plate spacer.
HINT: Align the pin of the front spacer with the pin hole of the crankshaft.

(e) Install the drive plate and rear drive plate spacer onto the crankshaft.

(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque: 98 Nm (999 kgf-cm, 72 ft-lbf)
3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)
(a) Clean the 8 bolts and 8 bolt holes.
(b) Apply adhesive to 2 or 3 threads of the 8 bolts.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(d) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque: 130 Nm (1326 kgf-cm, 96 ft-lbf)
4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle) Installation
5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle) Installation
6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
Refer to the procedures under "INSTALL AUTOMATIC TRANSAXLE ASSEMBLY". Installation
7. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
Refer to the procedures under "INSTALL MANUAL TRANSAXLE ASSEMBLY". Installation