Removal

AUDIO / VISUAL: FRONT DOOR SPEAKER: REMOVAL

REMOVAL
HINT:
- The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL Disassembly
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly





3. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
(a) Disengage the 3 claws and remove the front No. 2 speaker.
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL Disassembly
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY





(a) Disconnect the speaker connector.





(b) Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the No. 1 speaker.
(c) Move the drill around the rivet head circumference to cut the flange.
CAUTION: Be careful. The cut rivet is very hot.
NOTICE: Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

(d) After drilling out the flange, continue drilling to push out the shards on the drill.
(e) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.