Installation

E350 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

DIFFERENTIAL OIL SEAL: INSTALLATION





1. INSTALL TRANSMISSION CASE OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, tap in the oil seal.
SST: 09608-32010
SST: 09950-70010
09951-07200
Standard depth:
3.0 to 4.0 mm (0.118 to 0.158 in.)
NOTICE: Be careful not to damage the lip of the oil seal.





2. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, tap in the oil seal.
SST: 09608-10010
SST: 09950-70010
09951-07200
Standard depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
NOTICE: Be careful not to damage the lip of the oil seal.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Install drive shaft Installation.
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
(a) Install drive shaft Installation.
5. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)





6. ADD MANUAL TRANSAXLE OIL
Oil grade:
API GL-4 or GL-5
Viscosity:
SAE 75W-90
Standard capacity:
2.5 liters (2.6 US qts, 2.2 Imp. qts)
7. INSPECT MANUAL TRANSAXLE OIL
(a) Inspect transaxle oil Testing and Inspection.
8. INSPECT FRONT WHEEL ALIGNMENT
(a) Inspect wheel alignment Front Wheel Alignment.
9. INSTALL ENGINE UNDER COVER LH
10. INSTALL ENGINE UNDER COVER RH
11. CHECK ABS SPEED SENSOR SIGNAL
(a) Check the speed sensor signal Installation.