Removal

SUSPENSION: FRONT STABILIZER BAR: REMOVAL

FRONT STABILIZER BAR: REMOVAL

1. PLACE FRONT WHEEL FACING STRAIGHT AHEAD
2. REMOVE COLUMN HOLE COVER SILENCER SHEET Removal
3. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY Removal
4. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
5. REMOVE FRONT WHEEL
6. REMOVE ENGINE UNDER COVER LH
7. REMOVE ENGINE UNDER COVER RH





8. REMOVE FRONT STABILIZER LINK ASSEMBLY LH
(a) Remove the 2 nuts and front stabilizer link LH.
HINT: Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.

9. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

10. DISCONNECT TIE ROD END SUB-ASSEMBLY LH Removal
11. DISCONNECT TIE ROD END SUB-ASSEMBLY RH Removal
12. DISCONNECT PRESSURE FEED TUBE ASSEMBLY Removal
13. DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH Removal
14. DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

15. REMOVE FRONT FLOOR PANEL BRACE Removal
16. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal
17. REMOVE HOOD SUB-ASSEMBLY
18. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
19. SUSPEND ENGINE ASSEMBLY Removal
20. REMOVE NO. 1 HOOK Removal
21. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Removal





22. REMOVE FRONT NO. 1 STABILIZER BRACKET LH
(a) Remove the 2 bolts and front No. 1 stabilizer bracket LH from the suspension crossmember.
23. REMOVE FRONT NO. 1 STABILIZER BRACKET RH
HINT: Use the same procedures described for the LH side.

24. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
(a) Remove the 2 No. 1 stabilizer bar bushes from the stabilizer bar.
25. REMOVE FRONT STABILIZER BAR