Removal

C50 MANUAL TRANSAXLE: TRANSMISSION CONTROL CABLE: REMOVAL

REMOVAL

1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

2. REMOVE UPPER CONSOLE PANEL

3. REMOVE CONSOLE BOX REAR COVER

4. REMOVE CONSOLE BOX CARPET

5. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

6. REMOVE FRONT CONSOLE BOX

7. REMOVE FRONT FLOOR CENTER BRACE Removal

8. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR
9. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal







10. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Remove the 2 bolts and nut and remove the front No. 1 floor heat insulator.
11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Disconnect the control shift cable from the shift lever.
(b) Remove the clip and disconnect the control select cable from the shift lever.






(c) Turn the adjust nut 180°clockwise. While holding the adjust nut, separate the control cable assembly.






(d) Remove the 2 clips and the 2 washers, and disconnect the 2 cables from the transaxle.
(e) Remove the 2 clips and disconnect the 2 cables from the control cable bracket.






(f) Remove the 3 nuts and remove the transmission control cable.