FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2008 >> xD L4-1.8L (2ZR-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Seat Belt Systems >> Seat Belt >> Service and Repair >> Rear Center Seat Outer Belt Assembly >> Installation

Installation








SEAT BELT: REAR CENTER SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION
CAUTION: Always use "TORX" socket wrench E10 when installing the rear seat.

1. INSTALL SEAT BELT ANCHOR COVER






(a) Install the rear seat shoulder belt cover.
2. INSTALL SHOULDER BELT ANCHOR COVER RH






(a) Engage the 4 claws and install the seat belt anchor cover.
3. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY






(a) Check the angle of inclination required to lock the retractor.
(1) Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
NOTE: Do not disassemble the retractor.

If the operation is not as specified, replace the rear seat outer belt.






(b) Hook the lower stay of the retractor onto the 2 body hooks and install the retractor with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)






(c) Insert the hook into the body hole and install the bracket with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
(d) Check that the ELR locks.
NOTE: Perform the check with the rear center seat outer belt installed.
(1) With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the rear center seat outer belt.






(e) Install the through anchor with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)






(f) Engage the 2 claws and close the slip joint cover.
4. INSTALL ROOF SIDE INNER GARNISH RH Installation

5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation

6. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

7. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation

8. INSTALL REAR DECK TRIM COVER Installation

9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

10. INSTALL REAR DOOR SCUFF PLATE RH Installation

11. INSTALL REAR SEAT ASSEMBLY RH Installation

12. INSTALL NO. 1 REAR SEAT LEG COVER Installation

13. INSTALL DECK BOARD SUB-ASSEMBLY Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
pro multis Credits:Operation CHARM About Operation CHARM