Disassembly

CLUTCH: CLUTCH MASTER CYLINDER: DISASSEMBLY

DISASSEMBLY

1. REMOVE CLUTCH MASTER CYLINDER KIT





(a) Using a pin punch and hammer, tap out the slotted spring pin.
(b) Remove the inlet union and grommet.
(c) Loosen the lock nut, and remove the clevis.
(d) Remove the lock nut from the push rod.
(e) Remove the boot from the cylinder body.






(f) Using snap ring pliers, remove the snap ring while pushing on the piston rod.
(g) Remove the push rod from the cylinder body.
NOTE: The piston may pop up out of the cylinder body. Therefore, slowly remove the push rod from the cylinder body.

(h) Remove the stop plate and push rod.
(i) Remove the piston with the spring from the cylinder.
NOTE: Be careful not to damage the inside of the cylinder body.