SRS Warning Light Remains ON

SRS Warning Light Remains ON

DESCRIPTION
The SRS warning light is located on the combination meter.

The SRS warning light is located on the combination meter. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from the LOCK position to the ON position, and then goes off automatically.

If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver of a problem.

When terminals TC and CG of the DLC3 are connected, the DTCs are displayed by blinking the SRS warning light.

Wiring Diagram:

INSPECTION PROCEDURE

CAUTION: Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment.

1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
3. Disconnect the connectors from the center airbag sensor.
4. Disconnect the connectors from the horn button.
5. Disconnect the connectors from the front passenger airbag.
6. Disconnect the connector from the No. 1 instrument panel airbag lower.
7. w/ Side and curtain shield airbag:
Disconnect the connector from the front seat airbag LH.

8. w/ Side and curtain shield airbag:
Disconnect the connector from the front seat airbag RH.

9. w/ Side and curtain shield airbag:
Disconnect the connector from the curtain shield airbag LH.

10. w/ Side and curtain shield airbag:
Disconnect the connector from the curtain shield airbag RH.

11. Disconnect the connector from the front seat outer belt LH.
12. Disconnect the connector from the front seat outer belt RH.

Step 1-2:

Step 3-4:

Step 4(Continued)-6: