Airbag System
DIAGNOSTIC TROUBLE CODE CHARTIf a trouble code is displayed during the DTC check, check the circuit listed for the code in the table given.
HINT:
- When the SRS warning light remains on and the DTC output is the normal system code, a voltage source drop is likely occurring. This malfunction is not stored in the memory by the center airbag sensor assembly. If the power source voltage returns to normal, the SRS warning light will automatically go off.
- When 2 or more codes are indicated, the code with the lower number appears first.
- If a code is not listed on the display chart, the center airbag sensor assembly may have failed.
- In the case of any malfunction concerning an open circuit, short to ground, short to B+, or squib malfunction, other trouble codes may not be detected. In this case, repair the malfunction currently indicated and then reinspect the system.
- Mark in the check mode column:
*1: DTC is not corresponding to the check mode.
*2: DTC is corresponding to the check mode.
- DTC which has the mark of the *3 is output only the equipped car of side and curtain shield airbag.
