Road Test

ROAD TEST

HINT: SET and "-", RES and "+", ON-OFF functions share the same switch. Operate the cruise control main switch according to the directions ( ) indicated on the switch.

1. PROBLEM SYMPTOM CONFIRMATION




a. Inspect the SET function.
1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push down the cruise control main switch to "SET/-".
4. After releasing the switch, check that the vehicle cruises at the set speed.

b. Inspect the "+" (ACCEL) function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push down the cruise control main switch to "SET/-".
4. Check that vehicle speed increases while the cruise control main switch is pushed up to "RES/+", and that the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily (approximately 0.6 second) push up the cruise control main switch to "RES/+" and then immediately release it. Check that vehicle speed increases by approximately 1.6 km/h (1.0 mph) (Tap-up function).

c. Inspect the "-" (COAST) function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push down the cruise control main switch to "SET/-".
4. Check that vehicle speed decreases while the cruise control main switch is pushed down to "SET/-", and the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily (approximately 0.6 second) push down the cruise control main switch to "SET/-", and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (Tap-down function).

d. Inspect the CANCEL function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push down the cruise control main switch to "SET/-".
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.

- Depressing the brake pedal
- Depressing the clutch pedal (Manual Transaxle)
- D position circuit in the park/neutral position switch ON -> OFF (The shift lever is moved from the D to the N, 2 or 1 position) (Automatic Transaxle)
- Pushing the ON-OFF button off
- Pulling the cruise control main switch to CANCEL

e. Inspect the RES (RESUME) function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push down the cruise control main switch to "SET/-".
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
- Depressing the brake pedal
- Depressing the clutch pedal (Manual Transaxle)
- D position circuit in the park/neutral position switch ON -> OFF (The shift lever is moved from the D to the N, 2 or 1 position) (Automatic Transaxle)
- Pulling the cruise control main switch to CANCEL

5. After pushing the cruise control main switch to "RES/+" at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed prior to the cancellation.