Shift Lock Control Solenoid Replacement

Shift Lock Control Solenoid Replacement

Removal Procedure

1. Remove the front floor console. Refer to Front Floor Console Replacement (Service and Repair).




2. Remove the selector linkage (2) from the selector lever.

* Remove the retaining clamp (1).
* Disconnect the selector lever from the bracket.




3. Remove the selector lever assembly.

* Disconnect the wiring harness plug (1).
* Remove the 4 bolts (2).
* Remove the selector lever assembly.




4. Remove the lock control solenoid selector lever lock (2).

Note: Note the configuration of cables.

* Disconnect the 2 wiring plugs (1) from the lock control solenoid.
* Remove the 2 bolts (3).
* Remove the lock control solenoid from the selector lever lock.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

Note: Note the configuration of cables.

1. Install the lock control solenoid for the selector lever lock (2).

* Insert the lock control solenoid for the selector lever lock.

Tighten the 2 bolts (3) to 4 Nm (35 lb in).

* Connect the 2 wiring plugs (1) to the lock control solenoid.




2. Install the selector lever assembly.

* Insert the selector lever assembly.

Tighten 4 bolts (2) 5 Nm (44 lb in).

* Connect the wiring harness plug (1).




3. Install the selector linkage (2) to the selector lever.

* Install the selector lever to the bracket.
* Install the retaining clamp (1).

4. Install the front floor console. Refer to Front Floor Console Replacement (Service and Repair).
5. Check the selector lever safety functions.
6. For reprogramming procedures, refer to Control Module References (Programming and Relearning).