Canister Purge Solenoid: Service and Repair

Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure

1. Open the hood.
Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .
2. Disconnect the battery.
3. Raise the vehicle all the way.




4. Remove the rear purge valve (2).

* Remove the vent line from carbon canister to the rear purge valve (4).
Disconnect the quick-release fitting.
* Remove the vent line from the rear purge valve (1).
Disconnect the quick-release fitting.
* Disconnect the wiring harness of the rear purge valve (3).
Disconnect the wiring harness plug.
* Release the bracket and remove the rear purge valve (arrows).




Installation Procedure

1. Install the rear purge valve.

* Install the rear purge valve at the bracket.
* Install the wiring harness at the rear purge valve.
Connect the wiring harness plug.
* Install the vent line at the rear purge valve.
Connect the quick-release fitting.
* Install the vent line at the carbon canister to the rear purge valve.
Connect the quick-release fitting.

2. Lower the vehicle all the way.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the battery.
Connect the ground clamp to ground terminal.

Tighten the ground clamp nut to 5 N.m (44 lb in).

4. For programming procedures, refer to Control Module References (Programming and Relearning) .
5. Close the hood.