Stabilizer Link: Service and Repair

NOTE: The content of this article/image reflects the changes called out by TSB: 05-03-08-008A.


Stabilizer Shaft Link Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the front wheel.
3. Disconnect the stabilizer link from the stabilizer shaft.





4. Disconnect the stabilizer link from the strut assembly and remove from the vehicle.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Connect the stabilizer link to the strut assembly.
- Tighten the stabilizer link nut to 110 Nm (81 ft. lbs.).





2. Connect the stabilizer link to the stabilizer shaft.
- Tighten the stabilizer link nut to 110 Nm (81 ft. lbs.).
3. Install the front wheel.
4. Lower the vehicle.