Alternator: Service and Repair

GENERATOR REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect negative battery cable.
2. Remove the drive belt.
3. Remove the supercharger.
4. Disconnect the generator connectors.




5. Remove the generator bolts.
6. Remove the generator from the vehicle.

INSTALLATION PROCEDURE




1. Position the generator on the engine.
NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the generator bolts.

Tighten
Tighten the generator bolts to 25 N.m (18 lb ft).

3. Connect the positive battery harness to the generator battery terminal.

Tighten the generator terminal nut to 20 N.m (15 lb ft).

4. Connect the generator harness connectors.
5. Install the supercharger.
6. Install the drive belt.
7. Connect the battery negative cable.