Checking the Dipswitch Relay Power Supply, Continued

Checking the Dipswitch Relay Power Supply, Continued






















- Connect a Jumper lead between terminals 1 (30) and 3 (87A) of the relay holder.
- Dipped beams should come on.

Checking the wiring harness.
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Checking the Filament Monitor, Headlamps

YES - Changing Components - II