Checking Operating Current to Stepping Motor Winding 2

Checking Operating Current To Stepping Motor Winding 2







- Connect a test lamp to pins 4 and 6 of the female connector.
- Activate the calibration function to run the stepping motor.







- Both the red and green LEDs should light up on the test lamp.

Checking The Wiring Harness
Jiggle the leads and in-line connectors at several places and in different
directions to reveal intermittent brakes and short circuits in the wiring
harness. Observe the multimeter, test lamp or diagnostic tool while doing
this.

Is the function correct?

NO - Rectifying the Lead

YES - Changing the Components