Checking Control Module Input

Checking Control Module Input:







- Turn the ignition switch to the ON position.







- Contact STC.







Test value: Bow Ready to Latch Right (STC)
The reading should be: NO

Checking the wiring harness
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Rectifying the Lead - II

YES - Continue with Checking Control Module Input.

















- Connect a jumper lead between pins 2 and 3 of the female connector.







Test value: Bow Ready to Latch Right (STC)
The reading should be: YES

Checking the wiring harness
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Rectifying the Lead - II

YES - Changing Components