Checking Speed Data From the ABS

Checking Speed Data From The ABS







Unplug the connector:
- H33-2
- Extract pin 6 from the male half of the connector
- Plug in the connector.

















- Connect a test lamp between B+ and the loose pin 6 on the female connector.







- Raise the rear end of the car.







- Turn the ignition switch to the ON position.







- Rotate the LH rear wheel.







- The test lamp should flash.

Checking the wiring harness
Jiggle the leads and-in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter test lamp or diagnostic tool while doing this.

Is the function correct?

NO - Rectifying the Lead - I

YES - Check, Speed Signal