Final Check, Fuel Fault, Continued - I

Final Check, Fuel Fault, Continued





- Turn the ignition switch to the OFF position.

Plug in the connector:
- EVAP canister purge valve





- Drive the car at a speed of 60-100 km/h with a steady throttle opening and the engine running at 1500-2750 rpm.
- Wait until the value is fully stabilized.

Test value:
Multiplicative Adaptation
State what the diagnostic tool shows:

-15% to +15% = The steps taken to rectify the fault were correct.

Other value = Refer to Fault Diagnosis General. Before Changing A Control Module