C2465

C2465
Pump Motor. Defective

Fault symptoms
ABS warning lamp on. ABS not functioning.

Conditions
The pump motor is monitored continuously for circuit continuity and short-circuiting. The pump-motor test starts when the ignition is switched ON and the road speed is above 6 km/h.

Diagnostic help
The pump motor can be activated using the diagnostic tool.
- Select "Activate"
- Select "Pump motor".
- If the ABS control module is not grounding (pin 16), DTC C2465 will be generated.

Diagnostic procedure
1. Checking Control Module Grounding

Unplug the connector

^ Control module, ABS (547)
Go to step 2

2. Checking Control Module Grounding

Part 1 Of 2:

Part 2 Of 2:

^ Connect a test lamp to B+ and pin 16.

^ The lamp should light.

Checking the wiring harness.
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter, test lamp or diagnostic tool while doing this.

Is the function correct?

NO
Go to step 3

YES
Go to step 4

3. Rectifying The Lead

^ Rectify the open circuit in the lead between pin 16 on the control module and grounding point G2.
When repair is complete
Go to step 6

4. Checking The Lead

^ Check for an open circuit or shorting in the lead and connectors between the pump and the control module.

Is the wiring OK?

NO
Go to step 5

YES
Go to step 6

5. Rectifying The Lead

^ Repair or replace the lead concerned.
When repair is complete
Go to step 6

6. Final Check

^ Clear the diagnostic trouble codes in all systems.

Carry out a drive cycle:

^ Drive the car at varying engine loads and engine rpm for five minutes.

Evaluate the drive cycle.

^ Check that the diagnostic trouble code has not recurred

Is the function correct?

NO
Go to step 8

YES
Go to step 7

7. Final Check

The steps taken to rectify the fault were correct.
Diagnosis is complete

8. Final Check

Diagnosis for this fault code is complete.
Refer to "Before Changing A Control Module" at General.