Rear Door Window Glass: Service and Repair

Rear Side Door Window Replacement

Removal Procedure

1. Lower the rear door window.
2. Remove the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement (Rear Side Door Water Deflector Replacement).
3. Remove the window guide channel from the rear door. Refer to Door Window Guide Replacement (Door Window Guide Replacement).
4. Disconnect the power window motor electrical connector, if equipped.




5. Slide the regulator arm roller (2) out of the window bottom channel (1).
6. Lift and remove the window from the rear door.

Installation Procedure





Important: Before installing the window into the door, check to see that the bottom channel is securely attached to the window. If the channel is loose, note the location of the channel on the window and then remove the channel from the window. Clean all remaining adhesive from the channel. Apply a bead of Automix Channel Bonding and Sidelite Adhesive, 3M P/N 08641, or equivalent, to the channel and install the channel onto the window. Refer to manufacturer's instructions for adhesive cure time.


1. Install the window to the rear door.
2. Slide the regulator arm roller (2) into the window bottom channel (1).
3. Connect the power window motor electrical connector, if equipped.
4. Install the window guide channel to the rear door. Refer to Door Window Guide Replacement (Door Window Guide Replacement).
5. Install the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement (Rear Side Door Water Deflector Replacement).