Front Suspension

Stabilizer Shaft Insulator Replacement

Removal Procedure

1. Lower the following components as an assembly as far as necessary in order to access the stabilizer shaft insulators. Refer to Front Suspension Crossmember Replacement (All Wheel Drive) (Front Suspension Crossmember Replacement)Front Suspension Crossmember Replacement (Two Wheel Drive) (Front Suspension Crossmember Replacement).

* The front suspension crossmember
* The trans support
* The front control arms
* The stabilizer shaft
* The stabilizer shaft links
* The stabilizer shaft clamps
* The stabilizer shaft insulators




2. Remove the 4 bolts from the stabilizer shaft clamps.
3. Remove the 2 stabilizer shaft clamps.
4. Remove the 2 stabilizer shaft insulators.

Installation Procedure

1. Position the stabilizer shaft on the crossmember.




2. Install the 2 stabilizer shaft insulators to the outer side of the rings (1) on the stabilizer shaft. Position the cutout (2) in the insulator toward the rear of the vehicle.
3. Install the 2 clamps to the insulators.





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the 4 bolts to the clamps. Tighten the bolts to 24 Nm (18 lb ft).
5. Install the stabilizer shaft and the crossmember to the vehicle. Refer to Front Suspension Crossmember Replacement (All Wheel Drive) (Front Suspension Crossmember Replacement)Front Suspension Crossmember Replacement (Two Wheel Drive) (Front Suspension Crossmember Replacement).