Compressor Clutch Plate/Hub Assembly Install (SP10 Compressor)

Compressor Clutch Plate/Hub Assembly Install (SP10 Compressor)




1. Place the clutch drive assembly to match the shaft serration with the drive hub serration.
2. Gently insert the clutch drive assembly.

Important: If the air gap is correct, proceed to the next step. If not, change the shim to meet the specified air gap.


3. Check the air gap with the feeler gauge roughly by pressing the clutch drive assembly before fastening the shaft bolt.

0.3-0.7 mm (0.012-0.028 in)




4. Use the DW-610-010 clutch hub holding tool (1) to keep the clutch drive assembly from turning.
5. Place the washer before fastening the shaft bolt.

Tighten the shaft bolt to 12-15 Nm (106-133 lb in).

6. Recheck the air gap with the feeler gauge.