Air Temperature Sensor ( Ambient / Intake ): Service and Repair

Intake Air Pressure and Temperature Sensor Replacement

Removal Procedure




1. Disconnect the engine wiring harness electrical connector (2) from the intake air pressure and temperature sensor.




2. Remove the intake air pressure and temperature sensor bolts.
3. Remove the intake air pressure and temperature sensor.

Installation Procedure




1. Lubricate the intake air pressure and temperature sensor O-ring with clean engine oil.
2. Install the intake air pressure and temperature sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the intake air pressure and temperature sensor bolts and tighten to 2.5 Nm (22 lb in).




4. Connect the engine wiring harness electrical connector (2) to the intake air pressure and temperature sensor.