Power Seat Drive Cable: Service and Repair

Drive Cable Replacement - Power Seat

Removal Procedure

Caution: Refer toSIR Handling Caution in Cautions and Notices.
1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the seat cushion. Refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.




4. Squeeze the collars of the cable in order to release the cable.




5. Pull the cable out of the fittings until the cable ends clear the fittings.
6. Remove the cable or cable/sensor assembly.



Installation Procedure





1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the cable retainers snap into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the seat cushion. Refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
4. Enable the SIR system. Refer to Enabling the SIR System in SIR.