Transmitter Pressure Malfunction

TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS

Transmitter Pressure Malfunction

NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs

MALFUNCTION CODE NO. 35, 36, 37 OR 38 (DTC C1716, C1717, C1718 OR C1719)


1. CHECK ALL TIRE PRESSURES

Check all tire pressures. Specifications.
Are there any tires with pressure of 64 psi or more?
YES- Adjust tire pressure to specified value.
NO- GO TO 2.

2. ID REGISTRATION AND VEHICLE DRIVING

1.Carry out ID registration of all transmitters. ID Registration Procedure.
2.Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
3.Check all tire pressures with CONSULT within 15 minutes after vehicle speed becomes 17 km/h (11
MPH).
Does "DATA MONITOR ITEM" display 64 psi or more?
YES- Replace transmitter. Service and Repair. GO TO 3.
NO- GO TO 3.

3. ID REGISTRATION AND VEHICLE DRIVING

1.Carry out ID registration of all transmitters. ID Registration Procedure.
2.Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
3.Check all tire pressures with CONSULT within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES- Inspection End.
NO- GO TO the inspection applicable to DTC.