Rear Coil Spring

COIL SPRING

Removal and Installation


REMOVAL

1.Remove wheel and tire using power tool.
2.Remove wheel sensor from wheel hub and bearing assembly. Wheel Sensor.

CAUTION:
Do not pull on wheel sensor harness.
3.Set jack under rear suspension beam.





4.Remove shock absorber lower side bolt. Rear Suspension.
5.Gradually lower the jack, and then remove coil spring and rear spring rubber seat (upper and lower).

INSPECTION AFTER REMOVAL

Check coil spring and spring rubber seat for deformation, cracks, and damage, and replace it if a malfunction is detected.

INSTALLATION

Installation is in the reverse order of removal.
- For tightening torque, Rear Suspension Assembly.
- Tighten wheel nuts to specification. Adjustment.





- When installing spring, be sure to securely install the spring end position aligned to flush of rear spring rubber seat (lower) as shown.