Front Seat Belt

SEAT BELTS

Removal and Installation of Front Seat Belt












CAUTION:
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.

REMOVAL OF SEAT BELT RETRACTOR

1.Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2.Remove the adjuster cover and D-ring anchor bolt.
3.Remove both the center pillar upper and lower garnish.

WARNING:
Do not reuse center pillar upper garnish if removed.
4.Pull the floor trim away from center pillar.





5.Disconnect seat belt tension sensor connector and pre-tensioner connector. Supplemental Restraint System (SRS).
6.Remove the outer anchor bolt.
7.Remove the seat belt retractor screw and anchor bolt, then remove the seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR

Installation is in the reverse order of removal.

REMOVAL OF SEAT BELT BUCKLE

1.Remove the front seat, Removal and Installation.





2.Disconnect the seat belt buckle harness connector (1).
White arrow indicates : Vehicle front

3.Remove the anchor bolt (A), then remove the seat belt buckle (2).

INSTALLATION OF SEAT BELT BUCKLE

Installation is in the reverse order of removal.