Removal And Installation

SHIFT CONTROL SYSTEM

Removal and Installation


CVT SHIFT SELECTOR ASSEMBLY COMPONENTS












CONTROL CABLE COMPONENTS












REMOVAL


CAUTION:
Make sure that parking brake is applied before removal and installation.
1.Place the shift selector in the "P" position.
2.Remove the center console assembly. Service and Repair.
3.Remove the instrument lower panel LH. Instrument Lower Panel LH.





4.Remove steering lock escutcheon (1).
5.Remove steering column cover screws (A), then remove steering column upper cover and lower cover (2).
6.Remove instrument lower covers (LH/RH). Component Parts.
7.Remove the glove box assembly. Service and Repair.
8.Remove the instrument lower cover (center) screws, disconnect power socket connector and then remove
the instrument lower cover (center). Component Parts.
9.Remove the instrument upper cover screws and then remove the instrument upper cover. Refer to
Component Parts.
10.Disconnect the CVT shift selector assembly harness connector.
11.Remove the key interlock cable from the CVT shift selector assembly. Service and Repair.
12.Remove the control cable from the CVT shift selector assembly.
13.Remove the nuts and the CVT shift selector assembly.

INSTALLATION

Installation is in the reverse order of removal.





- When installing the control cable (3) to the CVT shift selector assembly (2), make sure that the control cable socket is fully pressed into the CVT shift selector assembly (2), and the control cable end (1) is fully pressed in with the ribbed surface (A) facing towards the front of the vehicle.
White arrow indicates : Vehicle front
- After installation is completed, adjust and check the CVT position.
Shift Control System and Testing and Inspection.