Inspection After Installation

FRONT DOOR GLASS AND REGULATOR

Inspection after Installation


POWER WINDOW SYSTEM INITIALIZATION

If any of the following work has been done, initialize the system.
- Electric power supply to power window switch or motor is interrupted by blown fuse or disconnecting battery cable, etc.
- Removal and installation of the regulator assembly.
- Removal and installation of the motor from the regulator assembly.
- Removal and installation of the harness connector of the power window switch.
- Window is partly opened and/or closed many times without being fully closed.
- Removal and installation of the door glass.
- Removal and installation of the door glass run.
Initialization
After installing each component to the vehicle, follow the steps below.
1.Close all doors.
2.Turn ignition switch ON.
3.Open the window to its full down position by operating the power window switch.
4.Move the power window switch in the up direction (auto close position) and hold. Keep holding the switch even when window is completely closed, for at least 4 seconds.
5.Confirm the window is now operating correctly.

INSTALLED GLASS INSPECTION

- Make sure the glass is securely set into the glass run groove.
- Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and make sure the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the guide rail bolts, and the glass and guide rail bolts to correct the glass position.
- Make sure the system is normal with raising and lowering the glass.