Front Door: Adjustments

DOOR


Fitting Adjustment








FRONT DOOR

Longitudinal Clearance
1. Remove the front fender.
2. Loosen the front door hinge bolts.
3. Install the front fender. .
4. Open the front door and adjust up or down at the rear edge according to specification.
5. Remove the front fender.
6. Tighten the front door hinge bolts.


7. Install the front fender.

Surface Height Adjustment
1. Loosen the front door hinge nuts.
2. Adjust the surface height difference of the fender and the front door according to specification.
3. Tighten the front door hinge nuts. Service and Repair.

Striker Adjustment
1. Loosen striker mounting bolts to allow movement with the striker.










REAR DOOR

Longitudinal Clearance
1. Remove the center pillar upper and lower garnishes. .
2. Open the front door and loosen the rear door hinge bolts.
3. From inside the vehicle, loosen the upper hinge nut. Open the rear door, and raise or lower the rear door at the rear edge according to specification.
4. Tighten the rear door hinge bolts and nut.


5. Install the center pillar upper and lower garnishes. .

Surface Height Adjustment
1. Loosen the rear door hinge nuts.
2. Adjust the surface height difference of front and rear doors according to specification.
3. Tighten the rear door hinge nuts. Service and Repair.

Striker Adjustment
1. Loosen striker mounting bolts to allow movement with the striker.





Striker screws 16.7 N-m (1.7 kg-m, 12 ft-lb)
This movement will help in the door alignment