Shifter CVT: Adjustments

CVT POSITION

Inspection and Adjustment


INSPECTION

1.Place selector lever in "P" position, and turn ignition switch ON (engine stop).
2.Make sure that selector lever can be shifted to other than "P" position when brake pedal is depressed.
Also make sure that selector lever can be shifted from "P" position only when brake pedal is depressed.
3.Move the selector lever and check for excessive effort, sticking, noise or rattle.
4.Confirm the selector lever stops at each position with the feel of engagement when it is moved through all the positions. Check that the actual position of the selector lever matches the position shown by the shift position indicator and the manual lever on the transaxle.





5.The method of operating the selector lever to individual positions correctly should be as shown.
6.When selector button is pressed in "P", "R" or "N" position without applying forward/backward force to selector lever, check button operation for sticking.
7.Confirm the back-up lamps illuminate only when selector lever is placed in the "R" position. Confirm the back-up lamps do not illuminate when the selector lever is pushed toward the "R" position when in the "P" or "N" position.
8.Confirm the engine can only be started with the selector lever in the "P" and "N" positions.
9.Make sure transaxle is locked completely in "P" position.
10.When selector lever is set to manual shift gate, make sure that manual mode is displayed on combination meter.
Shift selector lever to "+" and "-" sides, and check that set shift position changes.

ADJUSTMENT

1.Place selector lever in "P" position.

CAUTION:
Turn wheels more than 1/4 rotations and apply the park lock.





2.Loosen nut (A) and place manual lever (B) in "P" position.

CAUTION:
Never apply any force to the manual lever.
3.Tighten nut. Removal And Installation.

CAUTION:
Fix the manual lever when tightening.