Removal And Installation

UPPER LINK

Removal and Installation


REMOVAL

1.Remove tires with power tool. Removal And Installation.
2.Remove wheel sensor and sensor harness. Removal And Installation.
3.Set jack under suspension arm.

CAUTION:
- Never damage the suspension arm with a jack.
- Check the stable condition when using a jack.
4.Remove eccentric disc, adjusting bolt, mounting bolt, and nut, then remove upper link.
5.Perform inspection after removal. Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level ground.
- Never reuse upper link mounting nut.
- Perform inspection after installation. Inspection.