Clutch Pedal Position Switch

CLUTCH PEDAL POSITION SWITCH

Component Function Check


1. CHECK FOR CLUTCH PEDAL POSITION SWITCH FUNCTION

1.Turn ignition switch ON.
2.Check the voltage between ECM harness connector and ground.





Is the inspection result normal?
YES- INSPECTION END.
NO- Proceed to .


Diagnosis Procedure


1. CHECK CLUTCH PEDAL POSITION INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect clutch pedal position switch harness connector.
3.Turn ignition switch ON.
4.Check the voltage between clutch pedal position switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK CLUTCH PEDAL POSITION SWITCH INPUT SIGNAL CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connectors.
3.Check the continuity between clutch pedal position switch harness connector and ECM harness connector.





4.Also check harness for short to ground and to power.
Is the inspection result normal?
YES- Perform the trouble diagnosis for power supply circuit.
NO- Repair or replace error-detected parts.

3. CHECK CLUTCH PEDAL POSITION SWITCH GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connectors.
3.Check the continuity between clutch pedal position switch harness connector and ground





4.Also check harness for short to power.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace error-detected parts.

4. CHECK CLUTCH PEDAL POSITION SWITCH

Check the clutch pedal position switch. .
Is the inspection result normal?
YES- Check intermittent incident. Intermittent Incident.
NO- Replace clutch pedal position switch. Exploded View.


Component Inspection


1. CHECK CLUTCH PEDAL POSITION SWITCH-I

1.Turn ignition switch OFF.
2.Disconnect clutch pedal position switch harness connector.
3.Check the continuity between clutch pedal position switch terminals as per the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 2.

2. CHECK CLUTCH PEDAL POSITION SWITCH-II

1.Adjust clutch pedal position switch installation. Adjustments.
2.Check the continuity between clutch pedal position switch terminals as per the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace clutch pedal position switch. Exploded View.