Reading and Clearing Diagnostic Trouble Codes

DIAGNOSIS SYSTEM (COMBINATION METER)

On Board Diagnosis Function


ON BOARD DIAGNOSIS ITEM

The combination meter allows the following diagnosis items with the on-board diagnosis function.






METHOD OF STARTING

1.Turn ignition switch ON, and switch the trip meter to "trip A" or "trip B".
2.Turn ignition switch OFF.





3.While pressing the meter control switch (1), turn ignition switch
ON.
4.Make sure that the trip meter displays "0000.0".
5.Press the meter control switch at least 3 times. (Within 7 seconds after the ignition switch is turned ON.)
6.The combination meter is turned to self-diagnosis mode.





All of the segments of engine coolant temperature gauge, fuel gauge, odo/trip meter, shift position indicator (A) for CVT models and information display illuminate.
NOTE:
- Check combination meter power supply and ground circuit when the self-diagnosis mode of the combination meter does not start. Replace combination meter if power supply and ground circuit are normal.
- If any of the dots are not displayed, replace combination meter.
- For M/T models, start-up lamp (B) illuminate instead of shift position indicator.
7.Each meter activates by pressing the meter control switch.





NOTE:
- If any of the meters or gauges is not activated, replace combination meter.
- The figure is reference.