Insufficient Cooling

INSUFFICIENT COOLING

Description

- Insufficient cooling
- No cool air comes out. (Air flow volume is normal.)


Diagnosis Procedure

NOTE:
Perform self-diagnosis with CONSULT before performing symptom diagnosis. If any malfunction result or DTC
is detected, perform the corresponding diagnosis.

1. CHECK MAGNET CLUTCH OPERATION

1.Turn ignition switch ON.
2.Turn fan control dial ON.
3.Press A/C switch.
4.Check that A/C indicator turns ON. Check visually and by sound that compressor operates.
5.Press A/C switch again.
6.Check that A/C indicator turns OFF. Check that compressor stops.
Is the inspection result normal?
YES- GO TO 2.
NO- Perform the diagnosis of "COMPRESSOR DOES NOT OPERATE" in "SYMPTOM DIAGNOSIS".
Compressor Does Not Operate.

2. CHECK DRIVE BELT

Check tension of the drive belt. Inspection.
Is the inspection result normal?
YES- GO TO 3.
NO- Adjust or replace drive belt depending on the inspection results.

3. CHECK REFRIGERANT CYCLE PRESSURE

Connect the recovery/recycling recharging equipment to the vehicle and perform the pressure inspection with the gauge. Symptom Table.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace parts depending on the inspection results.

4. CHECK AIR LEAKAGE FROM EACH DUCT

Check duct and nozzle, etc. of the air conditioner system for leakage.
Is the inspection result normal?
YES- Check air mix door cable installation and air mix door operation.
NO- Repair or replace parts depending on the inspection results.