Camshaft Gear/Sprocket: Specifications

Camshaft with the following procedure.






When the camshaft sprocket (INT) (2) and camshaft sprocket (EXH) (3) is removed, refer to the paint mark (A) put according to step "3". Securely align the knock pin and the pin hole, and then install them.






Tighten bolts in the following steps.

Secure the hexagonal part of camshaft using wrench to tighten mounting bolt.

Tighten camshaft mounting bolt.






Turn 30 degrees clockwise (angle tightening).

CAUTION:






Check the tightening angle by using an angle wrench [SST: KV-10112100 (BT-8653-A)] (B) or protractor. Never judge by visual inspection without an angle wrench.