Removal And Installation

IGNITION COIL, SPARK PLUG AND ROCKER COVER

Removal and Installation


REMOVAL

1.Drain engine coolant. Draining Engine Coolant.
2.Remove engine cover. Exploded View.
3.Remove air inlet tube assembly. Exploded View.
4.Remove PCV hose.
5.Remove rocker cover protector.
6.Disconnect ignition coil harness connector, and them remove ignition coil.

CAUTION:
- Never drop or shock ignition coil.
- Never disassemble ignition coil.
7.Move ignition harness.






8.Remove rocker cover.

- Loosen bolts in reverse order shown in the figure.

White arrow indicates : Engine front

9.Remove PCV valve and PCV hose, if necessary.
10.Remove rocker cover gasket from rocker cover.

INSTALLATION


CAUTION:
Do not reuse O-rings.
1.Install the rocker cover gasket to rocker cover.

CAUTION:
Check the gasket is not dropped.
2.Install rocker cover.





- Tighten bolts in two steps separately in numerical order as shown in the figure.






3.Install in the reverse order of removal, for the rest of parts.