Removal And Installation

WATER OUTLET

Removal and Installation


REMOVAL

1.Drain engine coolant from radiator. Draining Engine Coolant.

CAUTION:
- Perform this step when engine is cold.
2.Remove engine cover. Exploded View.
3.Remove battery. Exploded View.
4.Remove air duct (upper) and air cleaner cover assembly and air cleaner body assembly.
5.Disconnect radiator hose (upper). Exploded View.
6.Remove water outlet adaptor.
7.Disconnect connectors of engine harness around the battery.





8.Remove bracket (2), and disconnect engine harness clip. (transmission side and water outlet side)





9.Disconnect crankshaft position sensor harness connector.
10.Move engine harness, and keep a service area.
11.Remove water hose of each water outlet connection and heater hose.
12.Remove water outlet.
13.Remove engine coolant temperature sensor from water outlet, if necessary.

INSTALLATION

Note the following, and install in the reverse order of removal.
Water Control valve





- Install water control valve with making rubber ring (1) groove fit to water control valve flange (A) with the whole circumference.





- Install water control valve (2) with the arrow (A) facing up and the frame center part (B) facing upwards.