Removal And Installation

BRAKE PEDAL

Removal and Installation


REMOVAL

1.Remove instrument lower panel. Removal And Installation.
2.Disconnect the stop lamp switch and the brake pedal position switch harness connectors.





3.Rotate the stop lamp switch and the brake pedal position switch (1) counter clockwise to remove.
4.Disconnect the accelerator pedal harness connector and harness clip.





5.Remove snap pin (1) and clevis pin (2) from clevis (3) of brake booster.





6.Remove the steering member stay (1).
7.Remove the brake pedal assembly.

CAUTION:
Hold the brake booster and master cylinder assembly so as not to drop out or contact them other parts.
8.Remove accelerator pedal from brake pedal assembly. Refer to
Removal And Installation.
9.Perform inspection after removal. Adjustments.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)
NOTE:
The clevis pin may be inserted in either direction.
- Perform adjustment after installation. Adjustments.