Sunroof Motor Assembly

SUNROOF MOTOR ASSEMBLY

Component Function Check


1. CHECK SUNROOF MOTOR FUNCTION

Check tilt up/down & slide open/close operations with sunroof switch.
Is the inspection result normal?
YES- GO TO 2.
NO- Check sunroof switch. Sunroof Switch.

2. CHECK SUNROOF MOTOR ASSEMBLY INPUT SIGNAL

1.Start engine.
2.Drive the vehicle at more than 40 km/h (25 MPH).

CAUTION:
Always drive vehicle at a safe speed.
NOTE:
This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle.
If a road test is expected to be easier, it is unnecessary to lift the vehicle.
3.Check tilt up/down & slide open/close operations with sunroof switch.
Is the inspection result normal?
YES- INSPECTION END
NO- .


Diagnosis Procedure


SUNROOF MOTOR ASSEMBLY


1. CHECK SUNROOF MOTOR ASSEMBLY INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect combination meter harness connector and sunroof motor assembly harness connector.
3.Check continuity between combination meter harness connector and sunroof motor assembly harness connector.





4.Check continuity between sunroof motor assembly harness connector and ground.





Is the inspection result normal?
YES- Check combination meter. Power Supply And Ground Circuit.
NO- Repair or replace harness or connector.