Removal And Installation

SUNROOF MOTOR ASSEMBLY

Removal and Installation


REMOVAL


CAUTION:
- Before removing sunroof motor, check that glass lid is fully closed.
- After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
1.Fully close glass lid.
2.Remove headlining. Removal And Installation.





3.Remove sunroof motor.
1.Disconnect harness connector (A) from sunroof motor.
2.Remove sunroof motor assembly fixing screws (B), and then remove sunroof motor assembly.

INSTALLATION


CAUTION:
Before installing the sunroof motor assembly, be sure to the place the link and wire assembly in the symmetrical and fully closed position.
1.Move the sunroof motor assembly laterally by little so that the gear is completely engaged into the wire on the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunroof motor assembly with screws.
2.Install headlining.
NOTE:
After installation sunroof motor, perform additional service. Description.