Removal And Installation

SUNROOF UNIT ASSEMBLY

Removal and Installation


REMOVAL


CAUTION:
- Always work with a helper.
- Fully close the glass lid assembly, before removal, then never operate sunroof motor assembly after removal.
- After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
- When remove/install sunroof unit, use cloths to protect the seats and trim from damage.
- After installing the sunroof unit and glass lid, perform the leak test and check that there is no malfunction.
1.Remove glass lid. Removal And Installation.
2.Remove headlining. Removal And Installation.
3.Disconnect drain hoses.
4.Remove sunroof brackets mounting bolts, and then remove sunroof brackets.
5.Remove bolts from the front end and side rail, and then remove sunroof unit assembly from roof panel.
6.Remove sunroof unit assembly through the passenger compartment while being careful not to damage the seats and trim.

INSTALLATION

1.Temporarily tighten the mounting bolts to the both side of sunroof unit assembly.
2.Temporarily tighten the mounting bolts to the front end of sunroof unit assembly.
3.Temporarily tighten the mounting bolts to the sunroof brackets (LH and RH).
4.Tighten the installation points diagonally excluding the installation points of the sunroof brackets around the roof opening.
5.Tighten the sunroof bracket bolts of the vehicle side, and then tighten the bolt of the sunroof unit assembly side.
6.Tighten the mounting bolts to the front end and both side of sunroof unit assembly.
7.Connect drain hoses.
8.Install headlining. Removal And Installation.
9.Install glass lid. Removal And Installation.
10.Install side trims.
NOTE:
- After installation, perform fitting adjustment. Adjustments.
- After installation sunroof unit assembly, perform additional service. Description.